Note: The Freeway 3200 is no longer in production. New installations should use a Freeway 3115, a Freeway 3215, or a Freeway 3415 instead.

The Freeway 3200 supports up to 24 serial ports while consuming only a 2U space (about 3.5 inches) in a 19-inch rack. Two 10/100 Ethernet LAN connections are standard, and three PCI slots are available to accommodate either Intelligent Communications Processor boards (which manage the serial ports), or additional Ethernet interfaces. A hard disk or flash disk can be used for local storage of boot parameters and for custom network applications.

1. Intelligent Communications Processor boards (ICPs) manage the protocols and contain serial ports that connect to the WAN. The Freeway 3200 uses ICP2432 boards.


2. The maximum number of ports depends on the electrical interface. The larger number is the maximum ports when using the EIA-232 electrical interface. The smaller number is the maximum ports for all other electrical interfaces.


3. Ethernet interfaces after the first two occupy PCI slots which are normally occupied by an ICP board. Therefore, when configured for three Ethernets, the Freeway 3200 can only have two ICP boards installed, and thus is limited to 16 serial WAN lines (8 WAN lines if all ICPs are configured to use an electrical interface other than RS-232).


4. The magnetic IDE hard disk is optional; if specified, it replaces the IDE flash disk.


5. Weight excludes ICP boards.

The unit is encased in a black, 2U rackmount-type chassis which is 17 inches wide (19 inches to the outside of the rack-mount ears), 18 inches deep, and 3.5 inches tall. Airflow is from front to back, with two internal 50 CFM fans pulling filtered air into the case from the front, and blowing it out of the case at the back.

A full-width door at the front of the unit swings downward (or can be removed) to expose the reset and power switches and to give access to the floppy and CDROM drives. Power and hard-disk-activity LEDs on the front panel are visible either with the door open or closed. The power and reset switches, the floppy drive, and the CDROM drive are accessible only when the door is opened.

Connectors for a VGA monitor, a keyboard, a serial console, and two 10BaseT/100BaseTX Ethernet cables are available at the back of the chassis. The WAN connectors or additional Ethernet connectors are also at the back of the chassis.