General Navigation
 

The smallest WAN server in the 3000 series, the Freeway 3115 supports up to 8 serial ports, but consumes only a 1U space (about 1.75 inch) in a 19-inch rack. Two 10/100/1000 Ethernet LAN connections are standard, and one PCI slot slot is available to accommodate either an Intelligent Communications Processor board (which manages the serial ports), or additional Ethernet interfaces. A hard disk or flash disk can be used for local storage of boot parameters and for custom network applications.

Technical Specifications
System CPU: Intel-based
RAM: 8 GBytes
Bus: PCI
Operating System: BSD Unix
ICPs1 Max # of ICPs: 1 (PCI)
CPU: Motorola-based
RAM: 32 MB
Serial Ports Max # of ports: 4/82
Type: Full duplex, DMA support
Electrical Interfaces:
EIA-232, EIA-449 (422), EIA 530, V.35
LAN Connections Two 10/100/1000 Ethernets;
Additional Ethernets optional3
Disk Drives DVD/CDROM, SATA flash disk, optional magnetic SATA disk4
Physical Mount: Rackmount
Height: 4.4 cm (1.75 in.) 1u
Width: 43.2 cm (17 in.)
Depth: 54.2 cm (21.3 in.)
Weight5: 9.1 kg (20 lbs)
Environmental Temperature
Operating:
10 to 45 °C (50 to 113 °F)
Storage/Transit:
-25 to 70 °C (-13 to 158 °F)
Humidity
Operating:
10% - 90% (relative, 40 °C, non-condensing)
Altitude
0 to 10,000 feet
AC Power 100-120 or 200-240 VAC (Auto-sensing); up to 500 Watts
  Section Menu
Freeway Overview
Freeway 3115
Freeway 3215
Freeway 3415
Freeway 215
 

Previous Freeway Models:
Freeway 3114
Freeway 3214
Freeway 3414
Freeway 214
Freeway 3112
Freeway 3212
Freeway 3412
Freeway 3612
Freeway 3110
Freeway 3210
Freeway 3410
Freeway 3610
Freeway 3100
Freeway 3200
Freeway 3400
Freeway 3600
Freeway 500
Freeway 1150
Freeway 1200
Freeway 1300
Freeway 2000
Freeway 4000
Freeway 8800
 
 

  1. Intelligent Communications Processor boards (ICPs) manage the protocols and contain serial ports that connect to the WAN. The Freeway 3115 uses ICP2432 boards.

  2. The maximum number of ports depends on the electrical interface. The larger number is the maximum ports when using the EIA-232 electrical interface. The smaller number is the maximum ports for all other electrical interfaces.

  3. Ethernet interfaces after the first two occupy the PCI slot which is normally occupied by an ICP board. Therefore, when configured for 4 Ethernets (a dual-port Ethernet board has been installed), the Freeway 3115 cannot have an ICP board installed.

  4. The magnetic SATA hard disk is optional; if specified, it replaces the SATA flash disk.

  5. Weight excludes ICP boards.

 

The unit is encased in a black, 1U rackmount-type chassis which is 17 inches wide (19 inches to the outside of the rack-mount ears), 21.3 inches deep, and 1.75 inches tall. Airflow is from front to back, with three internal 7 CFM fans pulling filtered air into the case from the front, and two 15 CFM fans blowing air out of the case at the back.

A full-width door at the front of the unit swings downward (or can be removed) to expose the reset and power switches and to give access to the DVD/CDROM drive. Power, hard-disk-activity, and system health LEDs on the front panel are visible either with the door open or closed. The power and reset switches and the DVD/CDROM drive are accessible only when the door is opened.

Connectors for a VGA monitor, a keyboard, a serial console, and two 10BaseT/100BaseTX Ethernet cables are available at the back of the chassis. The WAN connectors or additional Ethernet connectors are also at the back of the chassis.

Refer to the Freeway 3115 Reference Sheet for further information.

 

Copyright © 2021, Protogate Inc.